No paint peeling, no peeling! Ultraviolet laser marking makes cable marking clearer

In the past, the main marking method of wires and cables was the ink jet coding method, and the markings were easy to fall off and fade. However, the wiring layout of the cables was generally used for a long time, which may be several years or ten years or even longer, and the environment of the cables was generally It is exposed in the air or buried in the ground, so the ink jet marking marks are often worn off and difficult to continue to function. Manufacturers of cables need a product that can permanently mark cables without peeling paint or falling off. UV laser marking machine can just solve this problem.

Cable UV Laser Marking Demonstration

A wire is a wire that conducts electricity. Nowadays, wires have been completely integrated into our lives and have become an existence that cannot be ignored. Due to the large number of various cables, which are crossed vertically and horizontally, it is often easy to confuse the functions of different cables, and the wire is an indispensable material for users in the process of electricity consumption. .

UV laser marking machine marking principle:

Ultraviolet laser marking machine belongs to a series of products of laser marking machine, but it is developed with 355nm ultraviolet laser. Compared with infrared laser, the machine adopts third-order intracavity frequency doubling technology. To a large extent, the mechanical deformation of the material is reduced and the thermal influence of processing is small, because it is mainly used for ultra-fine marking and engraving, especially suitable for food, medical packaging material marking, micro-hole drilling, high-speed division of glass materials and silicon wafers for complex pattern cutting and other applications.

UV laser marking machine

Advantages of UV laser marking machine:

Due to the extremely small focusing spot and the small processing heat-affected zone, the ultraviolet laser can perform ultra-fine marking and special material marking. It is the first choice for customers who have higher requirements for marking effect. In addition to copper materials, UV lasers are also suitable for processing a wider range of materials. Not only the beam quality is good, the focusing spot is smaller, and ultra-fine marking can be realized; the scope of application is wider; the heat-affected area is extremely small, and there will be no thermal effect, and no material burning problem; marking speed and high efficiency; the whole machine Stable performance, small size, low power consumption and other advantages. Laser marking is non-contact processing, no pollution, fast marking speed, and clear and permanent writing, which is the best choice for cable marking.