18W-35W high power green laser for precise cutting of tempered glass Before purchasing the green laser, Mr. Lin came to RFH to understand the cutting process of the green laser. In just ten seconds, a piece of tough tempered glass is accurately cut by the green laser, not only is the cutting completed, the cutting of the tempered glass is neat and free of burrs, and the quality fully meets the standard of a first-class product. In order to ensure the cutting effect of different products, Mr. Lin continuously put forward the requirements of cutting different materials, but whether it is the mobile phone motherboard, sapphire or camera module, it is precisely cut by this small green laser.

RFH 532nm green laser high-end marking car windshield LOGO   The customer uses the RFH green laser to hit the car windshield with high-definition, no blur   As an important part of car appearance, car windshield has strict requirements in production. The green laser marking logo on the windshield has also caused a lot of trouble in the industry. Some glass manufacturers once thought that the logo on the windshield should not be too tangled, so they used a weak marking technique. But it makes the quality unable to pass. Therefore, it can be seen that the text and pattern content such as the logo and model number marked on the windshield not only need to be fully presented on the glass, but also need not be corroded during the long-term baptism of wind and sand.

Nanosecond green laser drilling and cutting tempered glass   Glass laser cutting technology is mainly used in 3C electronic products, flat panel displays, utensil manufacturing and other products, and is widely used in products with high demand and stability. The size and quality of the drill hole also determines the quality of the product, so major manufacturers are trying their best to improve the quality of the drill hole.

The RFH green laser has unique insights in cutting tempered glass film. The non-contact cutting method only needs to move the emitted light spot on the surface of the tempered glass film to allow the low-temperature cold light source to cut. It only takes a few seconds to cut a tempered glass film, which greatly speeds up the entire production line. .