Maintenance of 3w and 5w UV Laser Marking Machines

For UV laser marking machines, 3w and 5w are common equipment types. 3w and 5w UV laser marking machines are constantly developing, but long-term use will also cause some damage, which is also a common problem with every machine. However, if we do good maintenance, it will not be so easy to damage the machine. Therefore, in the process of machine application, if there are some common failures, we need to do some proper operation methods to maintain the machine.

Next, let's talk about the maintenance of 3w and 5w UV laser marking machines. These are still essential as industrial equipment and machines. If the maintenance work is done well, the service life of the machine can be improved, and the failure of the machine in the normal working process can be reduced, thereby improving our work efficiency.

uv laser | green laser | Ultraviolet lasers | uv dpss laser | nanosecond laser | UV laser source | Solid State Lasers

UV laser marking machine

First of all, when we use the machine, we must pay attention to whether there is any deviation in the height of the lifting mechanical slide rail on the workbench. If so, we have to remember to adjust it to the correct height. Also, we should clean the scene in a proper way before using it. It is recommended to wash with some small towel moistened with ethanol and wipe in one direction. Secondly, it is the main box of the UV laser marking machine. The main box is a very important part and needs to be cleaned regularly. Managers can blow along the branch level. Remember, don't wash it with water, as there are still circuit boards inside, which is bad if it causes a short circuit.

Also, before we start the machine, we need to check if our phone settings have changed. We have to follow the instructions and the correct process to actually do it. During the operation of the equipment, the UV laser marking machine must pay attention to the damage of the power supply and wires. If this happens, we must avoid repairing the power supply and wiring first, otherwise it will cause a short circuit or even worse disaster.

Then there are the server computers. A lot of people in this place neglect to clean, but often it needs to be cleaned. During the cleaning process, try to work with one hand to prevent the current and the body from creating a flow loop and causing harm to the body. Always check the condition of various parts of the machine, including the operation of display lights and hot fans. If the equipment is found to be faulty, it must be dealt with in time.

The above is a little knowledge about the maintenance of 3w and 5w UV laser marking machines! I hope everyone has to help.