How to solve the problem of 532nm dpss laser cutting failure?

The laser cutting machine can produce exquisite objects through its own energy. But long-term use of the cutting machine will cause failures.

Through the video, we can see that the cutting machine failed to cut the material during the operation.Next, we solve the problem in turn.

1、Adjust software parameters

1. Adjust the control panel

2. Adjust RDWorks cutting software

We can adjust the parameters of the machine through the control panel and RDWorks cutting software .

2、Check lens

At the same time, Stain on the reflective lens will cause the reflectance to drop, If there are stains, you need to wipe them with a clean soft cloth and alcohol.

uv laser | green laser | Ultraviolet lasers | uv dpss laser | nanosecond laser | UV laser source | Solid State Lasers

3、Check laser light path

The light path will also affect the cutting effect. After wiping or replacing the lens, if the cutting is still not successful, you can check the light path to ensure that the light is correct.

4、Adjust the power of laser tube and power supply

If the material is too thick, after the speed has been reduced to 1, it still cannot be cut cleanly.We need to increase the power and replace the laser tube and power supply.Next, we can learn about the steps to replace the laser tube and power supply through the video.

If you are still in doubt during the use of the machine, you can leave a message or call us, we will be happy to help you!